Operation Verification

Verify that the TV cable, Ethernet LANLocal Area Network: A communications network that serves users within a local geographical area, typically over distances of around 100m. Wireless LANs use wireless communicaitons to network devices so there is no need for data cabling. cable, and power cables are not caught on or pinched by the equipment moving components, wheels, or frame.

Verify that the console powers up to the "Welcome" banner.

Verify that the console has the most current software version installed, update the software as necessary, see System Software .

Do the following console Diagnostic System Tests (Settings > System Settings > System Tests):

• Touchscreen Calibration: Follow screen prompts to complete test. When the test is completed the console will automatically exit and return to the System Tests menu.
• Touchscreen Test: Verify that there is a trace created that follows your finger movement across the touchscreen surface. Select Finish to exit. move your finger and verify that a trace follows
• Backlight Test: Tests the display backlight brightness. Follow prompts to complete test.
• RGB Test: Touch the screen to cycle through the test colors: Red, Green, Blue, White, & Black. Returns to the System Tests menu when completed.
• Numeric Backlight Test: Tests the controls numeric display brightness. Returns to the System Tests menu when completed.
• Numeric Display Test: Tests the controls numeric display. Returns to the System Tests menu.

Verify internet connectivity. Verify the following Connectivity parameters (System Settings > Connectivity):

• Status: Connected
• IP Address: Should show a valid IP address, not 0.0.0.0.

Verify the TV Channel Guide (System Settings > TV Settings > Channel Guide):

1. Verify that available channels match the channel list (check with the facility operator).
2. Rename the channels if necessary.
3. Set the default channel, if applicable.

Verify the movement controls:

• INCLINE and SPEED (TRMTreadmill)
• INCLINE and RESISTANCE (EFXElliptical Fitness CrossTrainer)
• STRIDE HEIGHT, RESISTANCE (AMTAdaptive Motion Trainer)
• RESISTANCE (UBKUpright Bike/RBKRecumbent Bike bikes, CLB)

Verify the handlebar HR sensosr and the wireless chest strap heart rate monitor (HRM) function:
Handheld handlebar HR sensor test

1. Start a workout and grasp the left and right handlebar heart rate sensors. The heart icon will blink for approximately 10 seconds while the heart rate is being computed. You must maintain contact with both metal HR sensors on each handlebar to ensure an accurate measurement.
2. Within approximately ten seconds, your heart rate number appears in the HEART RATE (HR) display. Perform the following checks if the HR number does not appear:
   1. Verify that the HR cable is properly connected.
   2. If the HR test failed, repeat the test with a different person. In rare instances, the handlebar sensors may not work properly for a few individuals.

Wireless HR Test Strap Test

Use a touchscreen (P62, P80, and P82) compatible commercially available heart rate chest strap to verify the wireless heart rate function (Any chest strap that supports Polar GymLink technology or you can purchase a chest strap from Precor, pn PPP0000AT190012101) .

1. Put on the heart rate chest strap and verify that the chest strap is operating correctly on a different machine and touchscreen console.
2. Then move to the test machine and console and verify that the test console wireless heart rate function is operating correctly and is properly indicating your heart rate.
   
   DO NOT hold onto the handlebars during this measurement or you’ll override the chest strap HR results.

Alternative Test Method

If you have a Precor Polar HRM simulator transmitter test box (Precor PN: PPP000000020045101), then use the test box to verify the wireless heart rate function.

1. Switch on the HRM simulator transmitter test box and verify the console is properly indicating the test box transmitted heart rate.