Scanning the TV Channel Guide

About

The console provides a Channel Guide SCAN function that builds a new TV Channel Guide list from the TV RFRadio Frequency: Identifies electromagnetic signals with frequency spectrum between the 3 kHz (3,000 hertz) to 300 GHz (300 billion hertz) range. input signal. If you do not have access too or cannot create a channel guide cloning USBShort for Universal Serial Bus, is an industry standard developed in the mid-1990s that defines the cables, connectors and communications protocols used in a bus for connection, communication, and power supply between computers and electronic devices. drive then the SCAN function is the next best available solution to create a new channel guide. However it is not with out cost, it can take anywhere from 1 to 2 hours to create the channel guide.

Note: This procedure assumes that the facility TV service provider has provided a console compliant TV RF input signal.

Using SCAN to create the channel guide

This procedure assumes that there is a supported TV RF signal connected to the console tuner input port.

1. Access Service menu (51765761) > Settings menu.
2. Select System Setting > TV Settings > Channel Guide.
3. .Select the SCAN.button at the bottom of the Channel Guide screen.The console will begin to scan the TV input signal for all available channels. Each discovered channel will be listed in the Channel Guide. This process can take anywhere from 1 to 2 hours to complete.
4. Review and verify the Channel Guide list for expected channels. If any channels are missing, then repeat the scan using the Extensive Scan function.
   1. First enable the Extensive Scan property. From the TV Settings menu, select Extensive Scan > ON > OK.
   2. Then select Channel Guide > SCAN to start a new channel guide scan.
   3. When the scan is complete, review the Channel Guide and make any updates as needed.

Note: It can take 1 to 2 hours to complete the extensive scan.

5. Return to the "Welcome" banner, start a workout and verify the console TV operation.