Spinning® Studio Console
About
The Spinning® Studio Console is used on the Precor Spinner® Ride™, Spinner® Shift™, Spinner® Rally™, and Spinner® Climb™ indoor cycles.
|
Refer to the SPINNING® STUDIO Owner's Manual for the latest console installation, use, and service information. |
Features
- Battery Powered Console and Cadence Sensor: The console is powered by 3 - AAA batteries and the Cadence sensor uses a CR2032 lithium coin cell battery.
- ANT+ANT+ (pronounced ant plus) is a wireless protocol for monitoring sensor data such as a person's heart rate or a bicycle's tire pressure connectivity: The console supports ANT+ wireless heart rate monitor chest straps (however the Polar or Suunto ANT+ brand heart rate monitor chest straps are not supported).
- Program Memory: The console maintains programming code during battery replacement.
Console installation and Set Up
- Batteries Required: three AAA batteries.
For instructions to install the console, see the the SPINNING® STUDIO Owner's Manual "Console Setup",see Operator's Guide.
Cadence (RPM) sensor installation
- Batteries Required: one CR2032 lithium coin cell battery.
For instructions to install the cadence sensor, see the Cadence Sensor Installation chapter in the SPINNING® STUDIO Owner's Manual, see Operator's Guide.
Heart Rate Belt Bluetooth Pairing
For instructions to use and pair a bluetooth heart rate belt, see the Pairing with your Heart Rate Belt chapter in the Operators Guide, see Operator's Guide.
Service and Maintenance
All information regarding the console installation, operation, service, and maintenance is provided in the SPINNING® STUDIO Owner's Manual, see Operator's Guide.