Belt Guard Cover Replacement
About
This procedure provides instruction to remove and install the front and rear Belt Guard Covers.
The front belt guard cover includes an access panel used to access the right tensioner nut and axle nut. It is easiest to remove the rear guard cover first and then the front guard cover, install in reverse order. All rear guard fasteners must be removed before the front guard can be removed.
Available Movies
|
belt Guard Cover Replacement |
Procedure
Review entire procedure before starting.
Removal instructions
-
Remove the rear (left side) belt guard cover
by removing the three outer 5 mm hex key fasteners (3x) and then the center 4 mm fastener (1x). Remove center 
4 mm hex key fastener last. Retain part(s) and/or fastener(s) for installation.
- Remove the front belt guard access panel
by removing the one fastener using a 5 mm hex key. Retain part(s) and/or fastener(s) for installation.
- Remove the front belt guard cover
by removing the 5 mm hex key (4x) fasteners. The 4 mm hex key center back cover bolt needs to also be removed to remove the front cover. Retain part(s) and/or fastener(s) for installation. - Position the crank arm to the 9 o'clock position and then carefuly slide the front cover over the crank arm and pedal to remove. Retain part(s) and/or fastener(s) for installation.
Installation Instructions
- Position the crank arm to the 9 o'clock position and then carefuly slide the front cover over the pedal and crank arm. Retain part(s) and/or fastener(s) for installation.
- Position the cover over the frame cover mounting bolts and secure using the 5 mm hex key fasteners (4x).
- Install the front cover access panel onto the front belt cover, insert the left side tabs first and close. Secure using the removed 5 mm hex key bolt (1x).
- Then install the rear (left side) belt guard cover , installing the center 4 mm hex key fastener (1x) first and then the three outer 5 mm hex key fasteners (3x).
See Also