Input Module Replacement

About

This procedure provides instruction to remove and replace the ACAlternating Current: electric current which periodically reverses direction between positive and negative polarity. Input Module.

Procedure

Review entire procedure before starting.

1. Set the treadmill circuit breaker to OFF and unplugDisconnect a device power cord plug or cable connector from the power receptacle or outlet. the treadmill’s power cord from the AC outlet.
2. Remove the treadmill’s hood.
3. Remove the two screws that fasten the AC input panel to the frame. Keep fasteners for replacement installation.



4. Incline the AC input panel from the frame and rotate it to expose the AC line cord clamp screws and input module screws
5. .Remove the mounting screws and remove the AC power cord clamp. Keep fasteners for replacement installation



6. Disconnect the AC line cord from the input module.
7. Disconnect the wiring from the AC input module (1 blue wire, 1 brown wire and 1 green/yellow wire).
8. Remove the mounting screws and remove the AC input module. Keep fasteners for replacement installation:
9. Set the AC input module in its mounting position with the side with two terminals facing the circuit breaker and install using the previously removed fasteners.
10. Re-connect the AC input module blue wire to terminal N, the brown wire to terminal L and the green/yellow wire to terminal E.



11. Insert the AC line cord firmly into the input module. Set the AC line cord clamp in its mounting position and fasten it with the previously removed fasteners.
12. Reinstall hood.
13. PlugDevice power cord connector or electrical cable male connector that is inserted into an electrical receptacle "outlet" (also called the plug-in). in the power cord and Switch the input power ON.
14. Verify treadmill operation per "" and return to service.

.See Also

Replacement Procedures