Power Cord Replacement
About
This procedure provides instruction to remove and replace the power cord.
|
CAUTION: Use only Precor OEM power cords. Do not remove or otherwise bypass the 3-prong plug with an adapter to use a non-grounded outlet. Do not plug the unit into a power transformer in an attempt to adjust the voltage requirements. Failure to follow these instructions might damage the unit and void the Precor Limited Warranty. |
|
|
CAUTION: The treadmill requires a 20-amp individual branch circuit grounded per NEC (National Electric Code) guidelines or local region electric code. |
Procedure
Review entire procedure before starting.
- Set the treadmill circuit breaker to OFF and unplugDisconnect a device power cord plug or cable connector from the power receptacle or outlet. the treadmill’s power cord from the ACAlternating Current: electric current which periodically reverses direction between positive and negative polarity. outlet.
- Remove the treadmill’s hood.
- Remove the two screws that fasten the AC input panel to the frame. Keep fasteners for replacement installation.
- Lift the AC input panel from the frame and rotate it to expose the AC power cord clamp screws.
- Remove the fasteners that retain the AC power cord clamp and remove the clamp. Keep fasteners for replacement installation.
- Disconnect the AC power cord from the input module.
- Feed the end of the replacement AC power cord that mates with the input module through its hole in the frame and firmly insert it into the input module.
- Set the AC power cord clamp in its mounting position and install using the previously removed fasteners.
- Set the AC input panel in its mounting position and install using the previously removed fasteners.
- PlugDevice power cord connector or electrical cable male connector that is inserted into an electrical receptacle "outlet" (also called the plug-in). in the power cord and Switch the input power ON.
- Verify treadmill operation per "" and return to service.
.See Also