Auto Stop Troubleshooting
Apple To: TRM800-14TRM800 version 2 treadmills mfg. dates 2014 and later., TRM700-16 and later treadmill models
This troubleshooting procedure only applies to TRM800-14, TRM700-16 and later treadmill models that utilize software and drive motor current input to manage the auto stop function. For early production models like the TRM10TRM800 version 1 treadmills mfg. dates 2010 thru 2014. treadmill that utilize mechanical magnetic sensor input to manage the auto stop function, refer to the Error Code Troubleshooting Guide for troubleshooting information.
Auto stop is a safety feature that shuts off a treadmill that has been abandoned while the belt is running. Exclusive of the first sixty seconds after a workout has begun or resumed, any 30 second window with no user detected will prompt a 10 second countdown and then a full stop. The detection is accomplished through software, and is rated to detect persons weighing 50 lbs (22.7kg) or greater walking with a normal cadence.
The feature is selectable ON or OFF in the facility settings menus. It is default from the factory set to ON, and it is recommended to be set ON.
Related Error Codes
| RELATED ERROR CODE |
DESCRIPTION |
|---|---|
| none |
Troubleshooting Procedure
Access the Hardware Validation (51765761), and select the Auto Stop test.
P10, P30, P30i and P31 consoles:
When the feature is enabled, the " USER DETECTED" message is shown if motion is detected from the running deck or NO USER DETECTED if no motion is detected. It may take 5 or 6 steps for the USER DETECTED message to be displayed. This cycle will start over if the speed is changed.
P62, P80, and P82 consoles:
When START is pressed, after a few steps the status line will show USER DETECTED and the STEP COUNT will indicate the number of steps. If steps are not detected, the NO USER DETECTED message will be shown in the status field.
If the Auto Stop Feature did not pass the test replace the motor controller module.
See Also