You are here:

Fixed Arms Replacement

About

This procedure provides instruction to remove and install the Fixed Arms.

Specifications

System Component	Specification
Fixed Arm Mounting Bar Nylock Set Screw	300 in-lbs (34 Nm)
Handlebar Mount Clamp Fastener	144 in-lbs (16.3 Nm)

Procedure

Review entire procedure before starting.

Removal Instructions

Repeat this procedure for both the right and left Fixed Arms.

Remove the Top Lift cover, see Front Lift Cover Replacement.
Use a 3/16" hex key to remove the Fixed Arm Mounting Bar - inner and outer Nylock set screws. Do not loosen and then retighten the Nylock set screw, this will damage the Nylock patch. Discard and do not reuse the Nylock set screws.

CAUTION: Do not reuse the inner or outer Nylock patch set screws for installation. Either removing or loosening the Nylock set screw will compromise the integrity of the Nylock patch. Discard and order new set screws for installation (see Exploded View Diagrams, bubble # 252).

Remove the two 5/32" hex key Handlebar Mounting Clamp fasteners located at the front top of the console mount weldment. Hold arm while removing clamp.
Carefully remove the fixed arm mounting spud from the mounting bar.
Repeat procedure for both left and right Fixed Arms.

Installation Instructions

Reinstall the Fixed Arm onto Fixed Arm Mounting Bar and the Handlebar mounting bracket.

Position the Fixed arm into the Handlebar Mounting Bracket. Secure using the Handlebar Mount Clamp and two 5/32" hex key fasteners. Fully tighten and torque fasteners to 144 in-lbs (16.3 Nm).
Reinstall the Inner and Outer 3/16" hex key Nylock set screws, torque fasteners to 300 in-lbs (34 Nm)

Repeat procedure for both left and right handle bars.
Verify machine operation and return to service, see Operation Verification.

Contact Precor Customer Support (Ph 800.786.8404) with any questions.