Front Stabilizer Replacement

About

This procedure provides instruction to remove and install the Front Stabilizer.

Specifications

System Component Specification
Stabilizer fastener TorqueTorque is a measure of the force that can cause an object to rotate about an axis. Bolt/nut example: 5 nM torque is equivalent to 5 newtons of force applied one meter from the center of the bolt, 6 ft-lb is equivalent to 6 lb of force applied 1 foot away from the center of the bolt. 15.6 ft-lbs (21 N•m)

Procedure

Review entire procedure before starting.

Removal Instructions

  1. Place a soft mat under the bike frame and stand the bike frame on its back resting on the rear stabilizer and seat rail.
  2. Remove and retain the two stabilizer feet.
  3. Remove the front stabilizer by removing the two mounting bolts and washers using a 6 mm hex key. Retain fasteners for installation.

NOTE: The stabilizer attachment bar can slide within the mounting bracket. Make sure the attachment bar remains in position.

    Installation Instructions

  1. Position the front stabilizer onto the frame and fasten using the two stabilizer mounting bolts and washers, torque to 15.6 ft-lbs (21 N•m).
  2. Install the two stabilizer feet.
  3. Return bike to the upright position.
  4. Make sure the bike is level and setting firmly on the floor, see Leveling Adjustment Procedure.
  5. Verify bike operation per Operation Verification checklist and return to service.

See Also

Rear Stabilizer Replacement

Leveling Adjustment Procedure

Replacement Procedures

 

Contact Precor Customer Support (Ph 800.786.8404) with any questions.

Copyright 2016 Precor Incorporated