Handlebar Adjustment Knob Replacement

About

This procedure provides instruction to remove and install the Handlebar Adjustment Knob.

Procedure

Review entire procedure before starting.

Removal Instructions

  1. Remove the handlebar assemble off the post slider, see Handlebar Adjustment Knob Replacement.
  2. Fully tighten the handlebar adjustment knob. This will push the locking nut slightly above the bottom edge of the adjustment knob bracket exposing the locking nut.
  3. To remove the adjustment knob, use a thin wall 5/16' deep socket to hold the locking nut from turning while loosening the adjustment knob. Keep light pressure on the adjustment knob while loosening.

Installation instructions

  1. Reinstall the handlebar adjustment knob in reverse order.
  2. Reinstall the handlebar assembly and verify the handlebar adjustment knob operation, see Handlebar Assembly Replacement.

See Also

Replacement Procedures

 

Contact Precor Customer Support (Ph 800.786.8404) with any questions.

Copyright 2016 Precor Incorporated