Auto Stop Magnet Replacement

About

This procedure provides instruction to remove and replace the Auto Stop Magnet.

Procedure

Review entire procedure before starting.

CAUTION: Do not place the Auto Stop Magnet on or near a steel structure. If the magnet assembly comes in contact with a steel structure and then pulled away from the steel structure, the magnet can become dislodged from the magnet assembly housing. Contact PRECOR customer service for repair or replacement.

1. Set the treadmill circuit breaker to OFF and unplugDisconnect a device power cord plug or cable connector from the power receptacle or outlet. the treadmill’s power cord.
2. Remove the front hood.
3. Remove the left and right trim strips from the treadmill deck.
4. Remove the four mounting bolts and two top plates that fasten the running deck to the pivot bracket at the back of the treadmill. Keep fasteners for installation.
5. Pull the running deck out from the right side of the treadmill just far enough to expose the front right edge of the running deck, see Orientation.



6. Pry out the two push fasteners from the deck using a flat head screw driver and remove the Auto Stop Magnet. Keep fasteners for installation.



7. Align the replacement magnet on the running deck and then secure the magnet to the running deck using the two push fasteners.
8. Slide the running deck back into position over the running deck pivot bracket. Align the bottom plate and pivot bracket holes with the running deck bolt holes. Insert and tighten deck mounting bolts.
9. Check the alignment of the magnet and the auto stop assembly, see Auto Stop Sensor Replacement.
10. Replace the trim strips and front hood.
11. Connect the power cord and Switch the input power ON.
12. Verify the Auto Stop function by doing the Auto Stop diagnostics test, see .
13. Verify treadmill operation per "" and return to service.

.See Also

Replacement Procedures

Running Belt and Deck Replacement