End Cap & Belt Guard Cover Replacement

About

This procedure provides instruction to remove and replace the End Cap and belt guard covers.

Procedure

Review entire procedure before starting.

1. Switch the input power OFF and unplugDisconnect a device power cord plug or cable connector from the power receptacle or outlet. power cord.
2. Remove the four screws (2 lower screws, each side) that retain the end cap. Keep fasteners for installation. DO NOT loosen or move the Take‑Up roller mounting/adjustment bolts. Doing so will change the running belt’s tension and alignment.



3. To remove the end cap, slide the end cap off of the treadmill.

   

4. To remove the belt guard, press inwards on the belt guard to remove the belt guard tabs from the Take‑Up roller mounts. Slide the belt guard off of the treadmill.

5. To install the belt guard, slide the replacement belt guard into place so that the tabs on the belt guard engage in both Take‑Up roller mounts.

6. To install the rear guard, slide the end cap into place so that the tabs on the end cap engage in the notches in the running belt trim strips.

7. Secure end cap with fasteners.

See Also

Replacement Procedures

Running Belt and Deck Replacement

Take‑Up roller Replacement