General Information

Tools

The following tools are required to assemble Queenax products:

½” Drive hammer drill or Concrete drill
- masonry bits appropriately sized for anchor types (refer to mfg's guidelines for selecting anchor bolt bit sizes.)
- 3 mm, 6 mm, 10.5 mm, and 12.5 mm metal cutting bits
½” Drive Battery Impact Driver
Battery Angle Grinder
- Cutting disc and abrasive disc (grit #40)
Oscillating Tool (for cutting flooring)
- Wood and scraper blades
Laser measure
Utility Knife
Tap driver (10 mm & 12 mm cutting threads
Rubber mallet
Hammer
Ladders

Metric combination wrenches (13 mm, 17 mm, 19 mm, and 22 mm)
½” and 3/8” drive ratchets
TorqueTorque is a measure of the force that can cause an object to rotate about an axis. Bolt/nut example: 5 nM torque is equivalent to 5 newtons of force applied one meter from the center of the bolt, 6 ft-lb is equivalent to 6 lb of force applied 1 foot away from the center of the bolt. wrench 100 ft-lbs (136 N•m
Metric hex key set
½” metric hex key sockets from (6 mm – 10 mm, 13 mm, 17 mm, 19 mm, and 22 mm)
- 1 short set and 1 long set with ball end
3/8” metric hex sockets (13 mm, 17 mm, and comm
½” universal joint
½” to 3/8” socket adapter
½” short and long extensions
Metric tape measure
Vacuum cleaner

Note: One set of power tools per installer is recommended.

Safety Equipment

The following safety equipment is recommended:

Safety vest
Gloves
Respirator

Hard hat
Earplugs

Safety glasses
Safety toe work boots

Orientation

The equipment front, right, left, and back orientation.

Equipment Part and Option Identification

IMPORTANT: Always purchase OEM replacement parts and hardware from Precor. If you use parts not approved by Precor, you could void the Precor Limited Warranty. Use of parts not approved by Precor may cause injury.

Torque Specifications

This table provides a summary of system component specifications.

System Component	Specification
M10 Bolt torque	34 ft-lbs (46 Nm)
M12 bolt torque	58 ft-lbs (79 Nm)
M14 bolt torque	94 ft-lbs (127 Nm)
Expansion anchor bolt torque¹	37 ft-lbs, (50 Nm)
Note: 1) see Floor Anchoring Requirements

Cleaning

Wipe down equipment with recommended cleaning solution.
- General: 1 oz. mild soap to 30 oz. water. .

CAUTION: Do not use acidic cleaners and do not spray directly onto the equipment surfaces.

Rinse using a clean lint-free cloth and dampened with water only. Dry completely with another clean lint-free cloth.